If I replace a part on my SmarTracker, do I need to recalibrate?
- Motherboard computer
- No, unless the backup of configuration and calibrations was not performed.
- LVDTs
- Yes, the new LVDTs will need to be calibrated to the system
- RTD temperature probe
- Yes, the new RTD will need to be calibrated to the system.
- Motor controller or motor
- No, these do not influence the calibration.
- Resistive heaters
- No, these do not influence the calibration.
- Wheels
- Yes, these can change the wheel weight and will need to be recalibrated.
- PID temperature controller
- No, however, it is a good practice to test the system and verify the temperature is correct.
- Heater relays
- No, these have no effect on the calibration.